С чем это может быть связано? Ничего с Raspberry не делал. Поменял юсб кабель, не помогло.Recv: // Klipper state: Shutdown
Recv: // MCU 'mcu' shutdown: Timer too close
Recv: // This is generally indicative of an intermittent
Recv: // communication failure between micro-controller and host.
Recv: // Once the underlying issue is corrected, use the
Recv: // "FIRMWARE_RESTART" command to reset the firmware, reload the
Recv: // config, and restart the host software.
Send: N75959 G1 X162.468 Y110.921 E836.76708*99
Recv: // Printer is shutdown
Recv: !! MCU 'mcu' shutdown: Timer too close
Changing monitoring state from "Printing" to "Cancelling"
log: Что случается когда буфер переполняется?
Вспомнил. У меня слетела винда, пришлось восстанавливаться из бэкапов. В настройках солида поднял качество STL. Могло ли это сказаться? Но я печатал несложные модели. Какие параметры для STL оптимальны?