Калибровка экструдера: различия между версиями
Перейти к навигации
Перейти к поиску
AKDZG (обсуждение | вклад) (Новая страница: «Копипаст с https://sites.google.com/site/3dprinterlist/home/calculators/filament-drive-math Pi * (diameter of the shaft + diameter of the string) = Tota…») |
Dulfer (обсуждение | вклад) |
||
(не показаны 3 промежуточные версии 1 участника) | |||
Строка 28: | Строка 28: | ||
3.1415*(10+0.3)=32.35745 | 3.1415*(10+0.3)=32.35745 | ||
200*16/32.35745=98.895308499 or 98.89 | 200*16/32.35745=98.895308499 or 98.89 | ||
+ | |||
+ | |||
+ | |||
+ | == Полезные ссылки == | ||
+ | |||
+ | * [http://richrap.com/?p=54 richrap.com "Extruder Calibration"] | ||
+ | |||
+ | * [https://yadi.sk/i/w8rhXPohtNCWR Таблица калибровки по осям], автор setar (27.08.2012) | ||
+ | |||
+ | |||
+ | [[Категория:Калибровки]] |
Текущая версия на 18:29, 31 января 2018
Копипаст с https://sites.google.com/site/3dprinterlist/home/calculators/filament-drive-math
Pi * (diameter of the shaft + diameter of the string) = TotalDiameter
Steps per revolution * microstep / TotalDiameter = Step per mm
Having a 5 mm shaft and 0.33 mm string and 200 steps per revolution with 1/16 microstepping the math is:
3.1415*(5+0.33)=16.744195 200*16/16.744195=191.11100892 or 191.11 (the firmware only takes 2 digits)
And for instance
5mm shaft 0.44 string:
3.1415*(5+0.44)=17.08976 200*16/17.08976=187.246631901 or 187.24
5mm shaft 0.5 string:
3.1415*(5+0.5)=17.27825 200*16/17.27825=185.203941371 or 185.20
10mm shaft 0.3 string:
3.1415*(10+0.3)=32.35745 200*16/32.35745=98.895308499 or 98.89
Полезные ссылки
- Таблица калибровки по осям, автор setar (27.08.2012)